Basket Assembly

Installing a wire basket to your brand new 2WheelBikes beach cruiser will take approximately 5-10 minutes. Following the below instructions (using the pictures as a guide) will ensure that you can properly and safely install your wire basket

All you will need for installation of the basket is a screwdriver, a 14mm wrench, and an allen wrench (See Fig. 1).

Fig. 1



First, install the bracket to the basket using the screws and clamp provided. Be sure make sure it is snug, but still allow some give to allow movement of the bracket during installation. (See Fig. 2)


Fig. 2



Next, install the black bracket onto the basket using the screws and bolts provided. (See Fig. 3)

Fig. 3

Next, loosen the handle bar stem from the bike and place the black bracket around the handle bar stem. (See Fig. 4) Now install the handle bar stem back onto the bike. (See Fig. 5)

Fig. 4 / Fig. 5

Now loosen the bolts that hold the front wheel in place, and place the long bracket on the axle and replace the bolts (See Fig. 6). Now tighten the bolts and your basket is installed and ready for use.

Fig. 6